-50 Detune

[BottomBehavior]

This has been bugging me for a while,

Some time ago, I listened to a sequence with a marker that set the detune to "-50", despite only being able to slide down to multiples of 100.

Does anyone know how to do this?

The sequence that has it: [url=] [/url]

(Again, this is in a marker, not the instrument settings.)

[Cool172]

if you hold down shift while sliding the detune slider, it becomes unlocked. Additionally, your browser's console can be used to set exact detune values. If you make a marker for detune and reset it , it will change its value to whatever the global instrument setting is.

[Benvisions]

Some people on this site have really really unreasonably long bios, sometimes if I want to look at the person's profile it takes a while due to the length of their bio. It would be great if the number of characters was changed to a smaller amount. That would be great.

Hold shift or use console.

[BottomBehavior]

if you hold down shift while sliding the detune slider, it becomes unlocked.  Additionally, your browser's console can be used to set exact detune values. If you make a marker for detune and reset it , it will change its value to whatever the global instrument setting is.

Thanks!

[Hatchling]

Is there a way to make the detune outside of the normal 2 octave range? e.g. -24 to 24 instead of -12 to 12?

I tried editing the min and max values to something beyond -1200 and 1200 but it would always snap back to a hard-coded limit.

[Liam]

You can do it in the console: https://onlinesequencer.net/wiki/Console...nds#Detune . Same thing works for markers (see further down the page). It will be snapped back to the -1200 to 1200 range if you touch the slider in the advanced settings UI, so you have to be careful not to mess with it once you've run the console commands.

[extremonomia]

is there a bpm console command?

[Liam]

Yes, but it's not any more powerful than typing in the BPM. You're still limited to a min and max, and whole numbers only.

[pseudoname]

you can use inspect element to remove the max length attributes on the BPM text input, thus allowing higher values. you can't set it any lower than 10 though, anything lower just acts like 10